User manual

Problem Possible cause Remedy
The fuse in the house's electrical
wiring (fuse box) has been tripped
Check fuse. If the fuses trip several
times, please call a qualified elec-
trician
The microwave is not
working
The oven door is not properly
closed
Close the oven door
The door seals and door seal sur-
faces are dirty
Clean door seals and door seal sur-
faces
The Start button was not touched Press the Start button
The oven lighting is not
operating
The oven light bulb is faulty Replace oven light bulb
"d" is lit in the display
and the oven is not heat-
ing up. Fan not operating
Test mode is switched on Switch off the appliance Press and
hold the
and buttons at the
same time, until signal sounds and
"d" display goes out.
If you are unable to remedy the problem by following the above suggestions,
please contact your dealer or the Customer Care Department.
WARNING!
Repairs to the appliance must only be carried out by qualified service engineers.
Considerable danger to the user may result from improper repairs.
In the event of incorrect operation, visits by engineers from Customer Service or
the dealer may be chargeable, even during the warranty period.
Information for appliances with metal fronts: Due to the cool front of your appli-
ance, there may be short-term condensation of the inner door glass after opening
the door, during or shortly after baking or roasting.
Electrical Connection
The oven is designed to be connected to 230-240V~(50Hz) electricity supply.
The oven has an easily accessible terminal block which is marked as follows:
Letter L - Live terminal
Letter N - Neutral terminal
- Earth terminal
48
Electrical Connection