LAVAMAT 64850LE User manual Washing Machine
Contents Thank you for choosing one of our high-quality products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. We wish you much joy with your new appliance.
Safety information Environment concerns Packaging materials 34 35 Ecological hints 3 35 Subject to change without notice Operating instructions Safety information Read carefully & keep for future reference. • The safety of Your appliance complies with the industry standards and with legal re quirements on the safety of appliances. However, as manufacturers, we feel it is our duty to provide the following safety notes.
Safety information Installation • This appliance is heavy. Care should be taken when moving it. • When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre. • All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. See relevant section in the user manual.
Product description 5 • Make sure that children or pets do not climb into the drum. To prevent children or pets becoming trapped inside the drum the ma chine incorporates a special feature. To ac tivate this device, rotate the button (without pressing it) inside the door clockwise until the groove is horizontal. If necessary use a coin. To disable this device and restore the possibility of closing the door, rotate the button anticlockwise until the groove is ver tical.
Control panel 5 Drain pump 6 Adjustable feet Detergent dispenser drawer Compartment for detergent used for prewash . The prewash detergent is added at the be ginning of the wash programme. Compartment for powder or liquid detergent used for main wash . Compartment for liquid additives (fabric soft ener, starch). Compartment for stain remover used for main wash with STAIN option .
Display 7 8 START/PAUSE button 9 DELAY START button 10 Indicator pilot lights Symbols on the control panel : = Handwash = Cold = Rinse Hold = Child Lock Display 7.2 7.3 7.1 Duration of selected programme (7.1) : Duration of selected programme: After selecting a programme, the duration is displayed in hours and minutes (for example 2.05 ). The duration is calculated automatically on the basis of the maximum recommended load for each type of fabric.
Indicator pilot lights (10) Child safety lock (7.3) Indicator pilot lights (10) After having pressed the button 8 , the WASHING pilot light ( 10.1 ) comes on. When the pilot light 10.1 comes on this means that the machine is operating. The DOOR pilot light ( 10.2 ) indicates if the door can be opened: • light on: the door cannot be opened • light blinking: the door is opening • light off: the door can be opened When the appliance is performing additional rin ses the EXTRA RINSE pilot light ( 10.
Daily use 9 Daily use Load the laundry 1. Open the door by carefully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. 2. Close firmly the door. You must hear a click during closing. WARNING! Do not embed the laundry between the door and the rubber joint. Measure out the detergent and the fabric softener Your new appliance was designed to reduce water, energy and detergent consumption. 1.
Daily use 2. If required, pour fabric softener into the compartment marked (the amount used must not exceed the MAX mark in the drawer). Close the drawer gently. Select the required programme by means of programme selector dial (1) You can choose the right programme for any type of laundry following the descriptions on the washing programme tables (see «Washing Programmes»). Turn the programme selector dial to the required programme. The programme selector determines the type of washing cycle (e.g.
Daily use 11 Select the SPIN speed or the RINSE HOLD option (Button 3) When the required programme has been selected, your appliance automatically proposes the maximum spin speed provided for that programme. Press the button 3 repeatedly to change the spin speed, if you want your laundry to be spun at a speed different from the one proposed by the washing machine. The relevant light will light up.
Daily use Select the START/PAUSE (Button 8) To start the selected programme, press the button 8 , the corresponding red pilot light stops blinking. The pilot light 10.1 is on to indicate that the appliance starts operating. The pilot light 10.2 is on to indicate the door is locked. To interrupt a programme which is running, press the button 8 : the corresponding red pilot light starts blinking. To restart the programme from the point at which it was interrupted, press the button 8 again.
Altering an option or a running programme It is possible to change any option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing the button 8 . Changing a running programme is possible only by resetting it . Turn the programme and then to the new programme position. Start the new programme by selector dial to pressing the 8 button again. The washing water in the tub will not emptied out.
Helpful hints and tips Stand by : once the programme has finished after a few minutes the energy saving system will be enabled. The brightness of the display is reduced. By pressing any button the ap pliance will come out of the energy saving status. Helpful hints and tips Sorting out the laundry Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens.
Helpful hints and tips 15 Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quan tities to avoid waste and protect the environment. Although biodegradable, detergents contain substances which, in large quantities, can up set the delicate balance of nature. The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc.), the colour, washing temperature and degree of soiling.
Washing programmes Washing programmes Programme Maximum and Minimum Temperature Cycle Description Maximum Fabrics Load Type of Laundry Options COTTONS/LINEN 95° - Cold Main wash - Rinses - Long spin at the maximum speed Max. load 7 kg - Reduced load 3,5 kg White and coloured cotton (normally soiled items). SPIN REDUCTION RINSE HOLD STAIN1) SENSITIVE TIME2) EXTRA RINSE COTTONS WITH PREWASH 95° - Cold Prewash - Main wash - Rinses - Long spin at the maximum speed Max.
Washing programmes Programme Maximum and Minimum Temperature Cycle Description Maximum Fabrics Load Type of Laundry Options EASY IRON PLUS 60° - Cold Main wash - Rinses - Short spin at 1200 rpm Max. load 1 kg Synthetic fabrics to be gentle washed and spun. Selecting this programme the laundry is gently wash ed and spun to avoid any creasing. In this way ironing is easier. Furthermore the machine will perform ad ditional rinses.
Washing programmes Programme Maximum and Minimum Temperature Cycle Description Maximum Fabrics Load Type of Laundry Options SPIN Drain and long spin at the maximum speed Max. load 7 kg Separate spin for hand washed cotton garments and after programmes with the option selected, that ends with water left in the tub. Before selecting this pro . You gramme the selector dial must be turned to can choose the spin speed by pressing the relevant button to adapt it to the fabrics to be spun.
Care and cleaning 19 2) If you select the SUPER QUICK option by pressing button 6 , we recommend that you reduce the maximum load as indicated. Full loading is possible however with somewhat reduced cleaning results. 3) If using liquid detergents, a programme without PREWASH must be selected. Care and cleaning You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime.
Care and cleaning 2. Remove the conditioner insert from the middle compartment. 3. Clean all parts with water. 4. Put the conditioner insert in as far as it will go, so that it is firmly in place. 5. Clean all parts of the washing machine, especially the nozzles in the top of the washing-in chamber, with a brush. 6. Insert the detergent dispenser drawer in the guide rails and push it in.
Care and cleaning 21 • the machine makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump. Proceed as follows: 1. Disconnect the appliance. 2. If necessary wait until the water has cooled down. 3. Open the pump door. 4. 5. Place a container close to the pump to collect any spillage. Release the emergency emptying hose, place it in the container and remove its cap cover. 6. When no more water comes out, un screw the pump and remove it.
Care and cleaning 8. Put the cap back on the emergency emp tying hose and place the latter back in its seat. 9. Screw the pump fully in. 10. Close the pump door. WARNING! When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty.
Care and cleaning 23 5. Unscrew the hose from the machine. Keep a rug nearby because some water may flow. 6. Clean the filter in the valve with a stiff brush or with the piece of cloth. 7. Screw the hose back to the machine and make sure the connection is tight. 8. Turn on the water tap. Emergency emptying out If the water is not discharged, proceed as follows to empty out the machine: 1. pull out the plug from the power socket; 2. close the water tap; 3.
What to do if… 3. screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again. By doing this, any water remaining in the machine is removed, avoiding ice forming and consequently damage to the appliance. When you use the machine again, make sure that the ambient temperature is above 0°C.
What to do if… Problem The machine does not fill: 25 Possible cause/Solution The water tap is closed. • Open the water tap. The inlet hose is squashed or kinked. • Check the inlet hose connection. The filter in the inlet hose is blocked. • Clean the water inlet hose filter. The door is not properly closed. • Close firmly the door. The end of the drain hose is too low. The machine fills then empties immediately: • Refer to relevant paragraph in «Water drain age» section.
What to do if… Problem Possible cause/Solution Unsatisfactory washing results: Too little detergent or unsuitable detergent has been used. • Increase the detergent quantity or use an other one. Stubborn stains have not been treated prior to washing. • Use commercial products to treat the stub born stains. The correct temperature was not selected. • Check if you have selected the correct tem perature. Excessive laundry load. • Introduce into the drum less laundry.
Technical data Problem 27 Possible cause/Solution Machines based on modern technology operate very economically using very little water with out affecting performance. No water is visible in the drum: The display shows the alarm code : Anti-flooding system has activated. • Disconnect the appliance and contact the Service Force Centre If you are unable to identify or solve the problem, contact our service centre.
Installation Programme Energy consumption (KWh) Water consumption (litres) Synthetics 40° 0.6 54 Delicates 40° 0.6 63 Wool/ Handwash 30° 0.25 55 Programme duration (Minutes) 1) «Cotton Energy Saving programme » at 60°C with a load of 7 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards.
Installation 2. Remove the power supply cable and the draining hose from the hose holders on the rear of the appliance. 3. Unscrew the three bolts with the key sup plied with the machine. 4. Slide out the relevant plastic spacers.
Installation 5. Open the porthole, take out the inlet hose from the drum and remove the polystyr ene block fitted on the door seal. 6. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. 7. Connect the water inlet hose as described under the paragraph «Water inlet». Positioning and levelling Install the machine on a flat hard floor.
Installation 31 Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown. Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. Water inlet An inlet hose is supplied and can be found inside the machine drum. This appliance must be connected to a cold water supply.
Installation Water-stop device The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to nat ural ageing of the hose. This fault is shown by a red sector in the window «A» . Should this occur, turn the water tap off and refer to your Service Centre to replace the hose. WARNING! Installation should comply with local water authority and building regulations’ requirements.
Installation 33 When discharging into a standpipe ensure that the top of the standpipe is no more than 90 cm (35.4'') and no less than 60 cm (23.6'') above floor level. The drain hose may be extended to a max imum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18 mm. If your drain hose looks like this (see be low) you do not require the “U” piece”.
Electrical connection In the interest of the environment The appliance should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being dis charged safely into a river. It is essential that these appliances are not con nected to the surface water drainage system as this water is discharged directly into a river or stream and may cause pollution. If you require any further advice please contact your local water authority.
for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product.
132948280 - 00 - 432009 www.electrolux.