User manual

21
E10 appears.
The (END) indicator
flashes 1x, and an
acoustic signal sounds
1x.
(Problems with water
inflow.)
Tap turned off. Turn on the tap.
The filter in the threaded in-
let hose fitting is blocked.
Turn off the tap. Unscrew the
hose, take out the filter and
clean it.
Water tap is furred with
lime scale or is faulty.
Check the tap and have it re-
paired, if necessary.
The washing machine
vibrates when operating
or is not stable.
The transit packaging has
not been removed.
Removing the transit pack-
aging.
The screw feet not correctly
adjusted.
Adjust the feet as described
in the installation and con-
nection instructions.
Washing has not been
spun.
Only a few large items of
washing in the drum.
Always load the drum as full
as possible. Mix large and
small items.
Water is running out
from under the washing
machine.
Screw connection on the in-
let hose is leaking.
Screw the inlet hose on
tightly.
Drain hose is leaking. Replace drain hose.
Drain pump cover is not
closed properly.
Close the cover properly.
Washing was caught in the
door.
Load washing carefully for
the next wash.
Emergency drain hose is
leaking.
Close off emergency drain
hose properly.
EF0 appears. The
(END) indicator flashes
15x, and an acoustic
signal sounds 15x.
The drain pump is run-
ning continuously, even
when the appliance is
switched off.
The Aqua Control anti-
flooding system has been
activated.
Turn off the tap, remove the
power plug from the mains
socket and contact customer
service.
Wash water is foaming
excessively. At the end
of the washing cycle,
the spin stops. The
(OVERDOSING) indica-
tor lights up.
Too much detergent has
probably been used.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
Problem Possible cause Remedy