User Guide

ManualsBrandsAEG-Electrolux ManualsOtherS2673-6KA

Remove transport packaging

The appliance and the interior fittings are protected for transport.

• Remove all adhesive tape and packing pieces from the interior of the

appliance.

Disposal of old Appliances

For environmental reasons, refrigeration appliances must be disposed of

properly. This applies to your old appliance, and - at the end of its service

life - to your new appliance as well.

Warning! Before disposing of old appliances make them inoperable.

Remove plug from mains, sever the power cable, remove or destroy any

snap or latch closures, to prevent small children being trapped inside.

• Use an authorised disposal site.

Contact your Local Council or Environmental Health Office to see if there

are facilities in your area to recycle the appliance.

Reversing the door

The side the door opens can be changed from the right side (factory adjust-

ment) to the left side, if the installation site requires.

Warning! When changing the side the door opens, the appliance must not

be connected to the mains. Remove plug from the mains beforehand.

Proceed as follow:

1. Pull off ventilation grille (D) .

2. Remove blanking cover (F) from ven-

tilation grille by pushing it in the

direction of the arrow and refit it on

the opposite side.

3. Unscrew the bottom hinge and

remove the refrigerator compart-

ment door by pulling it downwards.

4. Unscrew the middle hinge and remo-

ve the freezer compartment door by

pulling it downwards.

5. With a screwdriver, unscrew the two

masking plugs covering the holes on

the left-hand side and refit them on

the right-hand side.

6. Unscrew the pin (G) from the top

hinge and refit it on the left-hand

side. Remember to fit the washers.

7. Slide the freezer compartment door

onto the top pin.

8. Insert the middle hinge into the bot-

tom of the freezer compartment

door. Remember to fit the washers.

9. Refit middle hinge screws.

10. Fit the refrigerator compartment

door onto the middle hinge.

11. Unscrew the bottom hinge pin and

refit it on the opposite side of the

hinge

12. Insert the bottom hinge into the bot-

tom of the refrigerator compartment

door.

13. Refit bottom hinge.