SANTO 60240 - 1 DT Kühl-Gefrierkombination Combiné réfrigerateur-congélateur Frigorifero-congelatore Gebrauchsanweisung Mode d’emploi Istruzioni per l’uso AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.
Chère Cliente, Cher Client Avant de mettre votre nouvel appareil en marche, veuillez lireattentivement le présent mode d’emploi. Vous y trouverez desinformations importantes sur la sécurité d’utilisation, l’installation etl’entretien de l’appareil. Conservez le mode d’emploi de manière à pouvoir le consulter par lasuite. Remettez-le à un éventuel nouveau propriétaire de l’appareil.
Dérangement L’appareil ne fonctionne pas. Cause possible L’appareil n’est pas mis en service. La fiche n’est pas branchée ou ne donne pas de contact. Le fusible a déclenché ou est défectueux. La prise de courant est défectueuse. L’appareil refroidit trop fortement. La température est réglée trop bas. La température est mal réglée. Les aliments sont trop chauds. L’éclairage intérieur ne pas fonctionne La porte est restée ouverte trop longtemps.
Sécurité La sécurité de nos appareils est conforme aux règles reconnues de la technique et à la loi sur la sécurité des appareils. Nous nous voyons cependant obligés de vous familiariser avec les conseils de sécurité suivants : Utilisation conforme à la destination • L’appareil de congélation est conçu pour une utilisation domestique. Il estadapté à la réfrigération, à la congélation de produits alimen-taires, au stockage des aliments surgelés, ainsi qu’à la préparation de glaçons.
Nettoyage et entretien Pour des raisons d’hygiène, il est nécessaire de nettoyer régulière ment l’intérieur de l’appareil, y compris les équipements intérieurs. Avertissement ! • Pendant le nettoyage, l’appareil ne peut pas être raccordé au secteur. Danger d’électrocution ! Avant tous travaux de nettoyage, mettre l’appareil hors service et tirer la fiche de la prise ou couper le fusible ou le tirer. • Ne jamais nettoyer l’appareil à l’aide d’appareils de nettoyage à l’aide de vapeur sous pression.
Elimination Congélateur Information sur l’emballage de l’appareil Le givre qui se forme dans le compartiment congélateur sera éliminé périodiquement à l’aide de une spatule en matière plastique. Il ne sera pas nécessaire de débrancher le réfrigérateur ou d’enlever les produits contenus dans le compartiment. Chaque fois que l’épaisseur de la couche de givre excède 5 mm env.
Préparer des glaçons 1. 2. Remplir le bac à glaçons aux 3/4 d’eau froide, le placer dans le surgéla-teur et laisser congeler. Pour enlever les glaçons préparés, tordre le bac à glaçons ou le placer un bref instant en dessous de l’eau courante. Attention ! Ne jamais décoincer un bac à glaçons qui serait collé par le gel à l’aide d’un objet pointu ou acéré.
Pour des raisons de sécurité, la ventilation doit être prévue comme indiqué dans la Fig. Attention: veillez à ne pas obstruer les overtures de ventilation. 100 mm Votre réfrigérateur a besoin d’air A 10 mm 10 mm B NP005 Entretoises postérieures Dans le sac avec la documentation, il y a deux entretoises qui doivent être montées dans les deux coins supérieurs. Introduisez les entretoises dans les trous situés à l’arrière de l’appareil (flèche (A) comme indiqué sur la fig.
Réfrigération Pour obtenir le meilleur rendement du compartiment réfrigérateur: • n’introduisez pas d’aliments encore chauds ou de li-quides en évaporation dans la cuve; • couvrez les aliments, surtout s’ils sont aromatiques; • placez les denrées de façon à ce que l'air puisse cir-culer tout autour. Où placer les denrées? Viandes (de toutes sortes): enveloppez-la dans des sachets en plastique et placez-la sur la tablette en verre au-dessus du(des) bac(s) à légumes.
Raccordement électrique Une prise de courant avec contact de terre installée réglementaire-ment est nécessaire pour le raccor-dement électrique. Il devrait être placée de façon à pouvoir retirer la fiche du câble d’alimentation. La protection électrique doit admettre un courant d’au moins 10 ampères. Si la prise de courant n’est plus accessible lorsque l’appareil est mis en place, un dispositif approprié de l’installation électronique doit garantir que l’appareil puisse être coupé du réseau (p. ex.