User Guide

15
D037
Defrosting
Refrigerator
Frost is automatically eliminated
during normal use. The defrost water
drains out through a trough into a
special container at the back of the
appliance, where it evaporates.
We recommend that you peridically
clean the defrost-water drainage
outlet with the cleaner provided,
located in the center of the drainage
groove.
Freezer
The freezer compartment, will become progrssively covered with frost. This
should be removed with al plastic scraper. Whenever the tickness of the fro-
st exceeds 4 mm complete defrosting should be carried out as follows:
1. pull out the plug from the wall socket or turn the thermostat knob to th “0”
setting.
2. remove any stored food, wrap it in several layers newspaper and put it in a
coll place.
3. leave the door open.
4. when defrosting is completed, dry the interior thoroughly
5. turn the thermostat knob to the required setting or raplace the plug in the
power socket.
Attention
Never use sharp metal tools to scrape off frost from the evaporator as you
could damage it.
Do not use a mechanical device or any artificial means to speed up the
thawing process other than those recommended by the manufacturer.
A temperature rise of the frozen food packs, during defrosting , may shor-
ten their safe storage life.
Switching off the appliance
To switch off the appliance, turn the temperature regulator to position "0".
If the appliance is not going to be used for an extended period:
1. Remove all refrigerated and deep-frozen packages as well as ice trays.
2. Switch off the appliance .
3. Remove the mains plug or switch off or turn out the circuit breaker or fuse.
4. Defrost freezer compartment and clean thoroughly (see section: “Cleaning
and Care”).
5. Leave the door open to avoid the build up of odours.
26
A
B
NP005
100 mm10 mm
10 mm
PR153
Colocação
Coloque o aparelho longe de qual-
quer fonte de calor (aquecimento,
fogões, ou raios solares demasiado
intensos).Verifique que nas parses
posterior, superior e inferior o ar
pode circular livremente. Para um
melhor funcionamento verifique
que a parse superior têm pelo
menos 100 mm de distancia de
algum móvel suspenso por cima do
aparelho (A). A solução preferível é
indicada na Fig. B (sem móvel). Um
ou vários pés niveladores situados
na base têm a função de nivelar o
aparelho correctamente.O aparelho
deve
poder ser desligado da rede;
uma vez realizada a instalação,
portanto, é necessário que a ficha
fique acessível.
Espaçadores posteriores
Na bolsinha da documentação
encontram se dois espaçadores
que hão de ser montados nos
cantos superiores da parte tra-
seira. Desapertar os parafusos,
inserir o espaçador debaixo da
cabeça do parafuso e voltar a
apertar.
Reversibilidade das portas
Antes de qualquer operação tire a
ficha da tomada de corrente.
Para a inversão aja da seguinte
maneira:
1. remover a dobradiça superior e o
suporte superior verificando que
a porta superior não se desen-
ganche: