User manual

Problem Possible cause Solution

The door is not closed correctly. Refer to "Closing the door".

The temperature regulator is not

set correctly.

Set a higher temperature.

Replacing the lamp

CAUTION!

Disconnect the plug from the mains socket.

1. Press on the rear hook of the lamp cover by a

screwdriver and at the same time pull and ro-

tate the cover in the direction of the arrow.

2. Replace the lamp with one of the same power

(the maximum power is shown on the light

bulb cover).

3. Install the lamp cover by fixing it into its orig-

inal position.

4. Connect the plug to the mains socket.

5. Open the door. Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to "Installation".

3. If necessary, replace the defective door gaskets. Contact the Service Force Center.

Technical data

Dimension of the recess

Height 1800 mm

Width 695 mm

Depth 669 mm

Rising Time 20 h

The technical information are situated in the rating plate on the internal left side of the

appliance and in the energy label.

Installation

WARNING!

Read the "Safety Information" carefully for your safety and correct operation of the ap-

pliance before installing the appliance.

Technical data