SANTO N 7 18 40-4i Integrated Fridge Freezer Operating and Installation Instructions AEG Addington Way LUTON Bedfordshire LU4 9QQ http://www.aeg.co.
Dear customer, Before switching on your new refrigerator/freezer on please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model.
Contents Place the small square on the guide again and fix it with the screws supplied. Should adjustment of the furniture door be necessary, use the clearance of slots. At the end of installation/adjusting, it is necessary to check if the door of the furniture closes properly. Hb PR168 Fix cover (Hd) on guide (Hb) until it clips into place.
Safety Fix cover (Hc) on guide (Ha) until it clips into place. Ha Please read this instruction book before using the appliance and retain for future reference. These warnings are provided in the interests of your safety, ensure you understand them fully before using the appliance. Intended Use • The appliance is intended for use in the home. It is suitable for the cooling, freezing and storing of frozen food, as well as for making ice.
Apply covers (C-D) into the relevant holes. Snap the ventilation grille (B) and hinge cover (E) into position. • When unplugging always pull the plug from the mains socket, do not pull on the cable. D Service C • Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local AEG Service Force Centre.
Remove transport packaging Instructions for building-in The appliance and the interior fittings are protected for transport. • Remove all adhesive tape and packing pieces from the interior of the appliance. Apply the joint sealing strip as shown in figure. Shelf holders A Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation.
1. 2. 3. . 4. 5. Unscrew the upper pin and remove the spacer Remove the upper door Starting up and temperature regulation Remove the hinge cover (A). Unscrew the pins (B) and the spacers (C) and refit them on the middle hinge of the opposite side. Snap the hinge cover (A).
Control Panel of Freezer Compartment This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located on the inside left of the appliance. The following table shows which ambient temperature is correct for each climate classification. 1 2 6 5 A 4 B Positioning 3 C D Climate classification for an ambient temperature of SN +10 to +32 °C N +16 to +32 °C A. Pilot light (green) B.
Installation Quick-freezing Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING – THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left.
Interior Accessories Guarantee Conditions Guarantee Conditions Storage Shelves The glass shelf above the fruit and vegetable compartment should always remain in position, to ensure fruit and vegetables stay fresh longer. The remaining storage shelves can be adjusted to various heights: Pull the storage shelf forward until it D338 can be tipped up or down and removed. To insert at a different height use the same procedure in reverse.
Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Service Force Centre by telephoning: 0870 5 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.uk.
• Allow warm food to cool down before freezing. The warmth will cause increased ice formation and increase the power consumption. • Please note the maximum storage times specified by the manufacturer. • Thawed foods which have not been processed further (cooked into meals) may not under any circumstances be frozen a second time. • Containers with flammable gases or liquids can leak at low temperatures.
Something Not Working Preparation of Ice Cubes If the appliance is not functioning correctly, please carry out the following checks before contacting your local AEG Service Force Centre. Warning! Repairs should only be carried out by qualified service engineers. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Symptom Possible Cause Remedy Appliance is not switched on Switch on the appliance. Mains plug is not plugged in or is loose. Insert mains plug.
We particulary recommend that you periodically clean the defrost-water drainage outlet, located in the centre of the drainage groove in the refrigerator compartment, to prevent the defrost water form overflowing on to foods stored in the compartment. Use the special cleaner provided, which you will find already inserted into the discharge hole. Freezer The inner walls of the freezer are automatically defrosted Switching off the appliance 1. 2. 3. 4.
