User manual

Starting the programme

Press the START PAUSE button. The programme is

started.

The programme progress is shown in LCD by ap-

propriate set of icons. From left to the right, from

IRON DRY

to ANTI-CREASE icon depends on

the drying cycle chosen. E. g. in case of STORAGE

programme the following status icons are visible:

. Current cycle progress is marked

by flashing dash under status icon. When appro-

priate part of drying cycle is accomplished dash

becomes steady and appears flashing under next status icon.

Changing programme

To change a programme which has been selected by mistake once the programme has

started, first turn the programme selector to OFF and then reset the programme.

The programme can no longer be changed directly once the programme has started.

Putting in extra items or taking items out before end of programme

1. Open loading door.

WARNING!

Laundry and drum can become hot. Risk of burns!

2. Load or remove laundry items.

3. Close loading securely. Lock must audibly lock.

4. Press the START PAUSE button to continue the drying cycle.

Drying cycle complete / removing laundry

Once the drying cycle is complete, display shows a blinking " 0 ", under anti-crease icon

appear dash. If the BUZZER button has been pressed, an acoustic signal sounds intermit-

tently for about one minute.

The drying cycles (except for the SHOES RACK and WOOL RACK programmes) are auto-

matically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates

at intervals during this phase. This keeps the laundry loose and free of creases. The laundry

can be removed at any time during the anti-crease phase. (The laundry should be taken out

towards the end of the anti-crease phase at the latest to prevent creases from forming.) If

LONG ANTI-CREASE

function has been selected, the anti-crease phase is lengthened by

60 minutes.

1. Open door.

2. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use

a damp hand for this purpose. (See “Care and cleaning” chapter.)

3. Remove laundry.

4. Turn the programme selector to OFF.

After each drying cycle:

Daily use