User manual

1. Unscrew cover above the bulb (this can be found directly behind the loading aperture,
at the top; refer to “Description of machine” section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket before screwing back the door light cover.
Do not operate the dryer when missing o-ring gasket on door light cover.
WARNING!
For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer
must not be operated.
Machine settings
Setting Implementation
Buzzer permanent
on/off
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS (DROOGTEGRAAD) and SPIN
SPEED (T/MIN) buttons and hold down for approx. 5 seconds.
3.
The buzzer is by default always off. You can use the buzzer option to
activate or deactivate sound but the machine does not memorise your
selection.
Water hardness
1)
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS (DROOGTEGRAAD) and TIME (TIJD
PROGR.) buttons and hold down for approx. 5 seconds. The current
setting is on the display:
–
low conductivity <300 μS/cm
–
medium conductivity 300-600 μS/cm
–
high conductivity >600 μS/cm
3. Press the START PAUSE (START PAUZE) button sequentially until you
set desired level.
4. To memorise setting press simultaneously the DRYNESS (DROOGTE-
GRAAD) and TIME (TIJD PROGR.) buttons or turn knob to OFF (UIT)
position
Emptying water res-
ervoir
- warning
off
2)
1. Turn the programme selector to any programme.
2. Press simultaneously the SPIN SPEED (T/MIN) and TIME (TIJD PROGR.)
buttons and hold down for approx. 5 seconds.
The current setting is on the display:
–
warning
icon and - warning message is off
–
warning
icon and - warning message is switched on
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the
end of the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity
values of the water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water reservoir
is full. When using an external drain for the condensed water warning can be offi
Machine settings
103