User manual

Changing programme

To change a programme which has been selected by mistake once the programme has

started, first turn the programme selector to OFF and then reset the programme.

The programme can no longer be changed directly once the programme has started. If

nevertheless there is an attempt to change the programme on the programme knob, the

programme progress display and the maintenance indicators flash. If an option (excluding

the buzzer ) is set, Err appears in the multidisplay. The drying programme is not however

affected by this (laundry protection).

Programme complete / Laundry unloading

Once the drying cycle is complete, display shows a blinking , under anti-crease icon

appears dash. If the buzzer option has been set, an acoustic signal sounds intermittently

for about one minute.

The drying cycles (except for the WOOL programme) are automatically followed by an anti-

crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase.

This keeps the laundry loose and free of creases. The laundry can be removed at any time

during the anti-crease phase. (The laundry should be taken out towards the end of the anti-

crease phase at the latest to prevent creases from forming.) If long anti-crease

option

has been set, the anti-crease phase is lengthened by 60 minutes.

1. Open door.

2. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use

a damp hand for this purpose. (See “Care and cleaning” chapter.)

3. Remove laundry.

4. Turn the programme selector to OFF (UIT).

After each drying cycle:

- Clean the micro-fine filter and fine filter

- Drain the condensed water container

(See chapter “Care and cleaning”.)

5. Close the door.

Daily use