User Guide

To deselect function press again LONG ANTI-CREASE (KNITTERSCHUTZ PLUS) button (2).

The LED above is off.

If this additional function is selected, the anti-crease phase at the end of the drying cycle

is lengthened by 60 minutes. The laundry can be removed at any time during the anti-

crease phase.

BUZZER (SIGNAL) function

The appliance is supplied with the BUZZER (SIGNAL) function deactivated.

The buzzer sounds or plays a tune when activated during:

– cycle end

– anti-crease phase and when phase starts or ends

– cycle interruption by a warning

–alarm

To activate it:

1. Choose the drying programme.

2. Press BUZZER (SIGNAL) button (3) - the LED above is on.

To deselect function press again BUZZER (SIGNAL) button (3). The LED above is off.

TIME (ZEITWAHL) function

To select the programme duration after setting the TIME PROGRAMME (ZEITPROGRAMM) .

You can select a programme duration from 10 mins to 3 hrs in 10-minute steps.

1. Turn the programme knob to the TIME PROGRAMME (ZEITPROGRAMM). The blinking

10' appears in the display. (corresponding to the cooling phase).

2. Press the TIME (ZEITWAHL) button (4) repeatedly until the desired programme duration

is shown in the display, e.g.

for a programme of 20 minutes.

If the programme duration is not selected, the duration is automatically set to 10 mins.

DELAY START (ZEITVORWAHL)

With the DELAY START (ZEITVORWAHL) button (6), you can delay the start of a

programme by between 30 minutes (30') and a maximum of 20 hours (20h).

1. Select the programme and additional functions if necessary.

2. Press the DELAY START (ZEITVORWAHL) button (6) as many times as necessary until the

required start delay appears on the display, e.g.

if the programme is to be started

in 12 hours.

If the display is showing 20h and you press the button again, the time delay will

be cancelled. The display will show 0' and then the duration of the selected pro-

gramme.

3. To activate the delay timer, press the START PAUSE button (5). The amount of time

remaining until the programme is set to start is continuously displayed (e.g. 15h, 14h,

13h, … 30' etc).

The delay time icon

is on.

Child lock

The child lock can be set to prevent a programme being accidentally started or a programme

in operation being accidentally changed. The child lock function locks all buttons and the

Daily use