User Guide

programme knob. The child lock can be activated or deactivated by holding down the

BUZZER (SIGNAL) (3) and TIME (ZEITWAHL) (4) buttons simultaneously for 5 seconds.

– Before programme is started: Appliance cannot be used

– After programme is started: Programme in operation cannot be changed

The

icon appears in the display to indicate that the child safety device is activated.

The child safety device is not deactivated once the programme comes to an end.

If you want to set a new programme, you must first deactivate the child safety device.

Starting the programme

Press the START PAUSE button (5). The LED above stops flashing, becomes steady. The

programme is started. Display shows elapsing cycle time or delay time if activated.

Changing programme

To change a programme which has been selected by mistake once the programme has

started, first turn the programme selector to OFF (AUS) and then reset the programme.

The programme can no longer be changed directly once the programme has started. If

nevertheless there is an attempt to change the programme on the programme knob, the

programme progress display and the maintenance indicators flash. If an option (excluding

the buzzer ) is set, Err appears in the multidisplay. The drying programme is not however

affected by this (laundry protection).

Drying cycle complete / removing laundry

Once the drying cycle is complete, display shows a blinking . If the BUZZER (SIGNAL)

button has been pressed, an acoustic signal sounds intermittently for about one minute.

The drying cycles are automatically followed by an anti-crease phase which lasts around

30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose

and free of creases. The laundry can be removed at any time during the anti-crease phase.

(The laundry should be taken out towards the end of the anti-crease phase at the latest to

prevent creases from forming.) If

long anti-crease function has been selected, the anti-

crease phase is lengthened by 60 minutes.

1. Open door.

2. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use

a damp hand for this purpose. (See “Care and cleaning” chapter.)

3. Remove laundry.

4. Turn the programme selector to OFF (AUS) .

After each drying cycle:

- Clean the micro-fine filter and fine filter

- Drain the condensed water container

(See chapter “Care and cleaning”.)

5. Close the door.

Daily use