User Guide

6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can be
obtained from your local service centre.
When the appliance is switched on, the interior lighting switches itself off after 4 minutes
when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the machine!
Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully
unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this can be found directly behind the loading aperture,
at the top; refer to “Description of machine” section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket before screwing back the door light cover.
Do not operate the dryer when missing o-ring gasket on door light cover.
WARNING!
For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer
must not be operated.
Machine settings
Setting Implementation
Buzzer permanent
on/off
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE (SCHON) and LONG ANTI-CREASE
(KNITTERSCHUTZ PLUS) buttons and hold down for approx. 5 seconds.
– diode above BUZZER (SIGNAL) button starts lighting - buzzer per-
manently on.
– lighting diode comes off - buzzer permanently off.
3. The buzzer is by default always off. You can use the BUZZER (SIGNAL)
button to activate or deactivate sound but the machine does not
memorize your selection.
Water hardness
1)
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE (SCHON) and TIME (ZEITWAHL)
buttons and hold down for approx. 5 seconds. The current setting is
on the display:
–
low conductivity <300 μS/cm
–
medium conductivity 300-600 μS/cm
–
high conductivity >600 μS/cm
3. Press the START PAUSE button sequentially until you set desired level.
4. To memorize setting press simultaneously the DELICATE (SCHON) and
TIME (ZEITWAHL) buttons or turn knob to OFF (AUS) position
Machine settings
95