User Guide

How to Maintain Your Vacuum Cleaner

Make sure vacuum cleaner is turned off and power cord is unplugged

1) Use handle release to lower handle

at onto oor (Fig. 1).

2) Remove 2 screws from the front side of

brush roll cover (Fig. 2).

3) Lift and remove brush roll cover (Fig. 3).

4) Remove brush roll and belt. Thread

new belt around motor shaft and

brush roll (Fig. 4).

5) Insert left end of brush roll rst. Make

sure square on brush roll cap is in

place. Pull right side of brush roll to

stretch belt. Secure right end cap into

base (Fig. 5).

6) Rotate brush roll 2 turns to center belt.

7) Replace brush roll cover (Fig. 2).

8) Replace 2 screws (Fig 6).

Check ZE090 Belt if Worn, Cut or Out of Shape

Avoid touching the motor shaft when checking brush roll belt.

Care should be taken when vacuuming rugs to ensure that edges and fringes do not snap

the drive belt and stop the rotation of the brush roll.

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Fig. 1

Maintain Brush Roll – Call Electrolux Customer Service HELPLINE

Motor can become hot with normal use.

Do not remove end caps. Remove hair and threads from brush roll periodically.

Electrolux Customer HELPLINE 08445 614614

www.electrolux.co.uk

Calls to this number will be charged at 5p per minute at all times from a BT Landline.