Installation Guide

--------------------------------------------------------------------------------7/32--------------------------------------------------------------------------------
3.3 Connecting of the power supply cable
The reader has to be supplied with 9..30V DC. The maximum output power of the power supply has to be
1.2 Watt. Be sure that you use the right polarity.
3.3.1 Using the pc connection cable ID 70213
Power supply: brown = + 9 .. 30 Volt
white = ground
3.3.2 Using the switchboard cable ID 70212
Power supply: brown = + 9 .. 30 Volt
white = ground
Data interface: green = RXD (readers data input)
yellow = TXD (readers data output)
grey = ground
3.3.3 Using a self assembled connecting cable
Using the following SAB cabs you can assemble your own connecting cable.
ID 70211 SAB cab with 1 PG9 cable pipe
ID 70215 SAB cab with 2 pre-assembled cable pipes
ID 70219 SAB cab without any cable pipe
You can use any shielded five-pole cable. The allowed diameter of the cable must be in the range from
∅3,5 to ∅8mm. For this case, IP 65 is reached.