User's Manual

--------------------------------------------------------------------------------7/8--------------------------------------------------------------------------------
figure 5.4.1 orientation 0° figure 5.4.2 orientation 45°
Figure 5.4.1 antenna under roller conveyors orientation 0°
Figura 5.4.2 antenna under roller conveyors orientation 45°
To get the best reading performance be sure to use at least 7 plastic rollers (without metal core) located
above the antenna. If you use less than 7 plastic rollers you will get shorter reading distance.
No metal can be present above or below the antenna (!)
6 Electrical connectors of the antenna
The antenna is connected with the decoder by the antenna-cable. Very low signals are conducted in the ca-
ble. Special attention should be paid at the cable routing that unnecessary external signals are not conduct-
ed. That is why the antenna-cable should be laid separately, particularly not in cable tunnels. Optimal read-
ing performance is achieved using the original AEG ID antenna-cable. This antenna-cable is delivered pre-
manufactured at the side of the antenna and fits to the reading system regarding shielding and cable capac-
ity. The standard cable length is 5 m. The cable may not be shortened!
Special cables with length of 1m to 10m are available on enquiry.
plastic roll
plastic roll
plastic roll
plastic roll
plastic roll
plastic roll
plastic roll
metal roll
metal roll
AAN FK6
plastic roll
plastic roll
metal roll
metal roll
plastic roll
plastic roll
plastic roll
plastic roll
plastic roll
AAN FK6