User's Manual

Rev 09
--------------------------------------------------------------------------------10/27--------------------------------------------------------------------------------
3.2.3 LED – LED control
With the command LED you can control the LED ring of the ARE DT1.
Input format: LED <SP> parameter <CR>
Output (example): 1 <CR>
Parameter:
PARAMETER FUNCTION
0 off
1 on
2 Buzzer beeps,
LEDs flash
final state =initial
state
3.2.4 RST – reset
With the command RST the reader does a warmstart and loads the saved settings from the internal
EEPROM. The antenna field is off after the reset.
Input format: RST <CR>
Output (example): ACK <CR>