User's Manual

---------------------------------------------------------------20/36-------------------------------------------------------------
Was the search successful a selection of possible partners will be shown. The Bluetooth partner
search can’t detect if a Bluetooth device supports the serial port profile, the user has to know
this. Was the search not successful the ARE H9 switches back to the “Set Interface” menu.
After choosing a partner from the found devices, the ARE H9 will try to establish a connection.
During this process the message “Await Connection” could appear, this is the case when the
partner is not ready or at the partner side additional activities are necessary.
A successful connection will be shown as follows:
Connected with
PC_007
5.5.4 Bluetooth Disconnect
Is the connection to the Bluetooth partner lost during the operating of the ARE H9, or
maximum Bluetooth distance has exceeded, the following display appears:
Await Connection
Abort ?
In this case will the ARE H9 wait as long as the connection is established again ort he user
cancels this screen by pressing both arrow buttons.
While switching off the ARE H9 the Bluetooth connection to a partner will automatically
disconnected.
5.6 Lock Up Reader
When lock up reader is activated the ARE H9 switches of immediately. After switching on the
pocked reader again it shows that it is locked.
During the ARE H9 is locked neither a reading process could started nor the menu could be
accessed.
While it is not unlocked, it will switch off again after 5 (default) seconds no button is pressed.
To leave this mode press both arrow buttons simultaneously.
Unlock Reader !
Press Both