Power Supply User Manual
36
3) Press ESC 4)
Press ▼ for the following
information
Note: When the mains is connected for the first time, the UPS does
not output any voltage (Figs. correspond to this status)
5) Press ▼ again 6) Press ▼ again
for the following information for the following inform.
Note: The status of each UPS module is displayed cyclically in the
bottom two lines.
7) Press the ▼ key again for the following information
Note: Battery status is
CHARGING, DISCHARGE
or BATT OPEN (battery not
connected).
LOAD: 0% BATT: 137
I / P VOLT: 232 232 231
O / P VOLT: 0
O / P FREQ: 0.0Hz
STATUS: NO OUTPUT
OUTPUT PARAMETER
RN SN TN
VOLT: 0V
CURR: 0A
FREQ: 0.0Hz
INPUT PARAMETER
RN SN TN
VOLT:
232 232 231
FREQ: 50.0Hz
RST INPUT
POWER PARAMETER
kW kVA
TOTAL: 0.00 0.00
UPS1: 0.00 0.00
UPS2: 0.00 0.00
BATTERY PARAMETER
BAT VOLT: 136V
VOLUME: 100%
STATUS: CHARGING