Power Supply User Manual

Explanations:

1 Power supply (UPS input)

can be locked using the position lock that comes included

2 Option for fixed ground

using extra screw

3 Automatically locking load segment connections

(UPS outputs) for critical loads with highest priority,

permanently directly supplied by the UPS (not manageable)

4 Manageable, i.e. via the UPS operating panel and

/ or the

software load segment connections Load circuit 1

(automatically locking)

5 Manageable, i.e. via the UPS operating panel and

/ or the

software load segment connections Load circuit 2

(automatically locking)

Remove the load plugs by pressing the red

button below each output outlet.

6 Separate fuse for the load circuit

for PROTECT D.3000

7 E

mergency Power Off,

optionally to be configured as opener or closer

8 Change-over contact,

potential-free, programmable using the UPS operating panel

9 Vent (Important: Allow for at least 100mm of free space

behind the vent to ensure proper ventilation)

10 USB communication interface

11 RS232 communication interface (sub-D9 jack)

12 Communication slot for optional extension cards:

Relay card, card for remote On/Off, SNMP, …

The USB and the RS232 communication

interfaces rule each other out, i.e. either USB o

RS232. The communication slot, on the othe

hand, is dual-monitor enabled, i.e. can be used

parallel to the USB or RS232 interface.