User manual

Problem Possible cause Remedy
Steam and condensation
settle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
The oven does not heat up. The necessary settings are
not set.
Make sure that the settings
are correct.
The turnspit does not rotate. The turnspit is not correctly
installed into the turnspit
hole.
Refer to "Using the turn-
spit".
It takes too long to cook the
dishes or they cook too
quickly.
The temperature is too low
or too high.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
14. INSTALLATION
WARNING!
Refer to Safety chapters.
14.1 Location of the appliance
You can install your freestanding
appliance with cabinets on one or two
sides and in the corner.
For minimal distances for fitting check
the table.
A
C
D
D
B
Minimum distances
Dimension mm
A 400
www.aeg.com24