User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. PRODUCT DESCRIPTION
- 4. BEFORE FIRST USE
- 5. HOB - DAILY USE
- 6. HOB - HINTS AND TIPS
- 7. HOB - CARE AND CLEANING
- 8. OVEN - DAILY USE
- 9. OVEN - CLOCK FUNCTIONS
- 10. OVEN - USING THE ACCESSORIES
- 11. OVEN - HINTS AND TIPS
- 12. OVEN - CARE AND CLEANING
- 13. TROUBLESHOOTING
- 14. INSTALLATION
- 14.1 Location of the appliance
- 14.2 Technical data
- 14.3 Other technical data
- 14.4 Bypass diameters
- 14.5 Gas burners for NATURAL GAS G20 2.0 kPa
- 14.6 Gas burners for LPG G30 2.8-3.0 kPa
- 14.7 Gas connection
- 14.8 Flexible nonmetal pipes connection
- 14.9 Adjustment to different types of gas
- 14.10 Hob injectors replacement
- 14.11 Adjusting the minimum gas level on the hob burner
- 14.12 Oven injector replacement
- 14.13 Adjusting the minimum gas level on the oven burner
- 14.14 Gas grill injector replacement
- 14.15 Levelling
- 14.16 Backguard
- 14.17 Electrical installation
14.15 Levelling
CAUTION!
Remove all the accessories
from the oven.
1. Disassemble the pan supports and all
the burner assemblies.
2.
Put the appliance on the sidewall on
a clean and smooth surface. Place
each foot into a separate hole, in the
plinth, and rotate it clockwise.
B
3. If the floor is not equally flat, use the
adjustable feet on the bottom of the
appliance to set a stable position for
the appliance.
To install all the accessories, do the first
step in an opposite sequence.
14.16 Backguard
Fix backguard B on the side holes C from
hob using a cross screwdriver and the
screws A.
A
A
B
C
C
14.17 Electrical installation
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
Connection to the mains
1. Fit the power cable with a
standardized plug suitable for the
load indicated on the data label.
2. Connect the wires as shown below.
3. Remember that the earth wire must
be longer than the phase wires
letter L (phase) = brown wire
letter N (neutral) = blue wire
www.aeg.com30