User manual

Problem Possible cause Remedy

The display shows an error

code that is not in this table.

There is an electrical fault. Deactivate the oven with the

house fuse or the safety

switch in the fuse box and

activate it again.

If the display shows the error

code again, contact the Cus-

tomer Care Department.

The display shows "12.00". There was a power cut. Reset the clock.

13.2 Service data

If you cannot find a solution to the

problem yourself, contact your dealer or

an Authorised Service Centre.

The necessary data for the service centre

is on the rating plate. The rating plate is

on the front frame of the appliance

cavity. Do not remove the rating plate

from the appliance cavity.

We recommend that you write the data here:

Model (MOD.) .........................................

Product number (PNC) .........................................

Serial number (S.N.) .........................................

14. INSTALLATION

WARNING!

Refer to Safety chapters.

14.1 Location of the appliance

You can install your freestanding

appliance with cabinets on one or two

sides and in the corner.

For minimal distances for fitting check

the table.

Minimum distances

Dimension mm

A 400

B 650

C 150

14.2 Technical data

Voltage 220 - 240 V

Frequency 50 / 60 Hz

Appliance class 1

Dimension mm

Height 885 - 915

Width 900