User manual

Detergent dispenser drawer
Compartment for prewash detergent and stain remover. The prewash
detergent is added at the beginning of the wash programme, the stain
remover during the STAIN-Action phase in the main wash at the optimal
time.
Compartment for powder or liquid detergent used for main wash.
It is emptied at the beginning of the wash cycle.
Compartment for liquid additives (fabric softener, starch).
It is emptied at the last rinse.
Compartment for bleaching agent.
It is emptied at the first rinse.
The quantity of additives and bleaching product must not exceed
the «MAX» mark in the drawer.
Before the first wash
Before your first wash, we recommend that you run a cotton cycle at
60°C, without any laundry in the machine, to remove any manufac-
turing residue from the drum and tub.
Pour 1/2 a measure of detergent into the dispenser drawer and start the
machine.
Cl
Programme chart
149
Modification of a programme which is running
To modify a programme, first set the machine to PAUSE by pressing the
START/PAUSE button .
Before the machine starts the heating phase, i.e. within the first 15
minutes for cotton programmes, 10 minutes for synthetic and delicate
programmes and 5 minutes for the wool programme, the selected wash
cycle can be modified.
Warning! If the programme selector dial is turned first to RESET O and
then to the new programme, the programme which is running is can-
celled, the water is emptied out and the machine re-starts from water
filling. To simply modify the programme which is running, turn the pro-
gramme selector dial to the desired position (avoiding the RESET position):
when the START/PAUSE button is pressed again, the machine restarts with
the newly selected programme from the point at which it was interrupted.
Opening the door after the programme has started
The door can only be opened before the machine starts the heating
phase (within the first 15, 10 or 5 minutes, depending on the pro-
gramme selected - see paragraph above) and during the rinse phase.
Set the machine to PAUSE (by pressing the START/PAUSE button).
If the door does not open, this means that the machine is already heat-
ing, or that the water level is above the bottom edge of the door.
This prevents large quantities of water from spilling out when the door
is opened.
148
Description of the applianceDescription of the appliance