User manual

GI--KWIK--ENG

Modicon Micro Quick-Start

Step 9. Connecting the Micro to your

Computer

You are now ready to complete the c onnections between the

Micro and your computer. This is the final step prior to configuring

and programming your Micro.

ProgrammiergerätMicro

COM1

Step 1 Plug the programming cable into the Comm1 port on

the lower middle section of the Micro.

Step 2 Plug the other end of the programming cable into the

DB-type adapter (either the 9- or 25-pin adapter).

Step 3 Plug the DB end of the adapter into the Comm1 port

on the rear of your computer.

Step 4 You have now made all required connections, and

are ready to communicate with and Autoconfigure the

Micro. Refer to Pages 15 -- 22 of the Micro

Ladder Logic Manual for specific information on these

operations.

All the documents you need to continue with the Micro’s

operations are included, either with the controller or with the

Modsoft Lite Software. This Quick-Start Guide was designed to

help you get up and running fast, and not to provide detailed

information about the Micro.