Manual

Door reversal
Selecting the drying programme
The appliance is supplied with the door opening from right to left.
If you wish to change the opening direction, proceed as follows:
1) Disengage the end of the opening stop (1) from the door and
turn it through 90° to remove it from its seat (Fig. A).
2) Using a screwdriver, turn plastic plug (2) through 90° to
remove it from its seat (Fig. A).
3) Fit plug (2) in the hole left free by opening stop (1) and turn
it through 90° to lock it in place (Fig. B).
4) Fit opening stop (1) into the hole from which plug (2) was
removed and turn it through 90°, making sure that the
latching tooth is facing towards the right (Fig. B).
5) Remove the door by unscrewing the screws securing it to the
bottom hinge (3-Fig. A).
6) Unscrew the two plastic screws (4-Fig. A) and fit them on the
opposite side (4-Fig. B).
7) Remove the catch hook (5-Fig. A) by inserting a screwdriver
into the upper hole and pushing downwards.
8) Remove plate (6) by inserting a screwdriver into the bottom
hole and pushing upwards (Fig. A).
9) Refit the catch hook (5) and plate (6) on the opposite sides
(Fig. B).
10) Remove the door catch (7) and plate (8) as explained in
paragraph 7.
11) Turn the door through 180°.
12) Refit the door catch (7) and plate (8), reversing their position
and pressing firmly to engage the hook (Fig. B).
13) Fit the door onto the machine. Insert the top pin first, then
the bottom pin into the hinge (3-Fig. B); finally screw the
hinge onto the machine.
14) Check that the doos is aligned with the appliance. To do this
loosen screw (9-Fig. B) by a couple of turns and re-tighten
when alignment is correct.
15) Fit the flexible end of the door opening stop into the location
provided in the door (1-Fig. B).
14
If you wish to carry out a drying cycle on its own, turn the pro
gramme selector knob clockwise to DRYING: programme 6 for
cottons, linens or programme 9 for synthetics.
DRYING TIME selector knob
With this knob, the drying time can be adjusted, up to a maxi
mum of 100 minutes for cottons (section U**«/) and synthetics
(section ).
Never attempt to turn the knob in an anticlockwise direction.
When selecting the drying time, take into account the type of
fabric to be dried (cottons, synthetics) and the degree of drying
required (cupboard dry, iron dry).
Refer to the chart.
When selecting the drying time, you should also remember that
it includes a 8 minute cooling phase.
For example, if you select a drying time of 60 minutes, the
machine will dry for 52 minutes and will then cool for the remain
ing 8 minutes.
As soon as the drying programme is started, the pilot light «Dry
ing« vSj comes on.
Cooling phase
8 minutes before the end of the cycle, an automatic cooling
phase is carried out to cool the laundry.
This phase cannot be shortened, stopped or avoided, as this
could cause skin burns or damages to the laundry.
Drying only
31