Instruction Manual

Installation instructions
There should be a minimum distance
of 5.02 m (16V2 ft) between the
appliance’s inlet and the bottom of
the tank.
There will be sufficient pressure for
the hot water supply from the hot
water cylinder if the height between
the appliance’s inlet and the bottom
of the cold water storage cistern (not
between the appliance and hot water
cylinder) is at least 2.74 m (9 ft).
If the machine is permanently
plumbed in, hook the end of the hose
into a standpipe installed for the
purpose.
The standpipe must have an internal
diameter of at least 30 mm (1 V z in),
in order that there is an air gap
between the drain hose and
standpipe. Make sure, that it is
designed in such a way, that the end
of the drain hose cannot be covered
with water.
11
Set the hose correctly by loosening
the ring nut. After positioning the
Inlet hose, be sure to tighten the ring
nut again to prevent leaks.
12
if you intend the drain hose from the
machine to empty into a sink, make
sure the sink is empty and that the
plug hole is not blocked.
Important: Before connecting up the
machine to new pipework or to
pipework that has not been used for
some time, run off a reasonable
amount of water to flush out any
debris that may have collected In the
pipes.
Whether discharging into a sink or a
standpipe check that the end of the
drain hose is neither too high nor too
low. The top of the curve In the
hose’s end should be no more than
90 cm (35.4”) and no less than 60 cfn
(23.6”) above floor level.
10
Cleaning the filter
The water drain filter
A clean filter is important for correct
functioning of the machine, and
should therefore be cleaned after
every wash.
Place a container underneath to
catch any spillage.
Unscrew the filter.
If the filter is blocked and the
machine is unable to drain you will
need to drain the water from the
machine at this stage.
To do this, unhook the drain hose
from the standpipe or sink and hold
the end of the hose over a bowl on
the floor. The water should drain by
gravity into the bowl. When the bowl
is full, hook the hose back up and
empty the bowl. Repeat the procedure
until the water stops flowing out.
Clean carefully under a fast-running
tap.
35