Instruction Manual

Servicing
■ PROBLEM • CAUSE SOLUTION
■ THE MACHINE DOES
• A drying programme
Select a drying
NOT DRY
has not been selected
programme
• The cold water tap is Turn the tap on
not on
• The drainage filtei' is
Clean the filter (see
clogged page 35)
• The machine is
Reduce the load
overloaded
• The drying time Is not
Refer to the programme
adequate
chart and set the
correct time (see pages
19-20)
■ THE DOOR DOES NOT
• The safety device has
>
Wait 1 - 2 minutes after
OPEN
locked it
the end of the
programme before
opening the door
• Water in the wash tub
Drain the water by
running the draining
programme (15)
If, after the above checks, there is
still a fault, call your nearest AEG
Service Centre.
Please make sure you give the model
and serial number of the appliance.
This information can be found on the
rating plate (see picture), or on the
guarantee certificate.
Original spare parts can be
purchased from AEG Spare Parts on
Slough 0753 872550.
In-guarantee customers should ensure
that the above checks have been
made as the engineer will make a
charge if the fault is not a
mechanical dr electrical breakdown.
Please note that proof of purchase is
required for any in-guarantee service
calls.
42
Warnings
It is most important that this instruction book should be retained with the
appliance for future reference. Should the appliance be sold or transferred
to another owner, or should you move house and leave the appliance,
always ensure that the book Is supplied with the appliance In order that
the new owner can get to know the functioning of the appliance and the
relevant warnings.
This appliance Is designed to be
operated by adults. Children should
not be allowed to tamper with the
controls or play with the product.
It Is dangerous to alter the
specifications or attempt to modify
this product in any way.
Any electrical work required to install
this appliance should be carried out
by a qualified electrician or
competent person.
Any plumbing work required to Install
this appliance should be carried out
by a qualified plumber or competent
person.
This product should be serviced by an
authorised AEG Service Centre, and
only genuine spare parts should be
used.
Care must be taken to ensure that the
appliance does not stand on the
electrical supply cable.
Always unplug the appliance and turn
off the water after use.
Do not overload the appliance. See
relevant section in Instruction book.
Always look through the glass door to
check if water has drained before
opening the door. If water is present
do not open door before draining the
water. If in doubt, refer to your
instruction book.
This appliance Is heavy. Care should
be taken when moving it.
All packing and transit bolts must be
removed .before use. Serious damage
can occur to the product and to
property if this is not adhered to. See
relevant section in Instructions.
The glass door becomes very hot
during the washing cycle. Keep
children away from the vicinity of the
appliance whilst it is in operation.
Leave the porthole door slightly ajar
between washes to preserve the door
seal. '
Only wash fabrics which are designed
to be machine washed. Follow the
Instructions given on fabric labels
(see chart «Wash code symbols».
Before washing, ensure that all
pockets are empty and buttons and
zips are fastened. Avoid washing
frayed or torn articles and treat stains
such as paint, Ink, rust, and grass
before^washing. Underwired bras
must not be machine washed.
Any objects such as coins, safety
pins, nails, screws, stones or any
other hard, sharp material can cause
extensive damage and must not be
placed into the appjiance.