302 D Cooker Hood Installation and Operating Instructions
Installing the hood to the wall It is possible to fix the hood in position, if necessary, by only attaching it to the rear wall. Proceed as follows: 1. Drill the four holes on the wall as indicated (Fig. 11). 2. Insert the four rawl plugs supplied into these holes. 3. Screw the two mountings hooks into the top two rawl plugs (Fig. 12). 4. Dismount the spacer M (Fig. 12) from the body of the hood by unscrewing completely the two spacer fixing screws O and washers. 5. Fix the base spacer M to the wall (Fig.
Using the hood It is advisable to switch on the cooker hood a few minutes before starting cooking and then to leave it running fot approximately 15 minutes afterwards to ensure that all odours are extracted. On the front of the appliance there are control switches (see page 3). The switch marked with motor symbol controls fan power. The switch marked with lamp symbol controls the lighting of the cooking surface.
AEG Hausgeräte AG Postfach 1036 D-90327 Nürnberg © Copyright by AEG H 260 251 240 L361C Ed.