Gas connection in accordance with currently valid regulations, connection of the hob In cation o the gas line must be made with upstream arrangement of a shutoff! cock This cock must be easily accessible at alt times, The connection to natural gas or town gas is made directly on the R%” connection. Connection to liquefied gas (propane butane} is made with intermediate arrangement of a tight connection piece with pipe, We recommend a safely gas socket in the right-hand adjoining cabinet.
Important hints prior to installation Connection During connection of the appliance, a device is to be provided which enables the appliance 1o be separated from the mains supply with an contact opening width of at least 3 mm. Suitable separating devices are automatic cut-outs, ruses, and contractors. Installation Please note halt, on building future, e synthetic coating or censer must be treated with heat resistant adhesive (100-Ct.
Fitting hints The minimum distance of the hob cutout at the rear is 55 mm and laterally to the wail 80 mm. The distance of the extractor hood to the hob unit must be observed in compliance with the installation instructions for the extraction hood! For the distance laterally to elevated cabinets, we recommend at least 300 mm to meet work performance requirements. N.B. Use no silicone adhesive tape for fitting of the build-in hob anti the worktop.
Operation The switch toggle {Fig. 5) of the required burner location is first rotated to the left {counterclockwise) to "rage Hammer. Then firmly press the toggle. Only then does gas flow from the burner and is safely ignited by the pursed sparks. The switch toggle must be pressed for a further few seconds (around 6-7} so that the gas supply automatically remains open (the thermometric then being adequately heated). It it is released too early, the flames will go out again.
Conversion of hobs to another gas type N. B. Prior to settling, the hob must be DE-energized Loosen retaining screw Fig. 2/1 and push back injector Fig. 2/2 until the fatter may be grasped. Change nozzle Fig. 2/3 according o nozzle table. Push toward injector until injector front edge and marking Fig. 2/4 on nozzle stem coincide. Lightly re tighten retaining screw Fig. 2/1. Finally, put oft switch toggles and unscrew console from lower side (2 Screws. Remove switch toggle. Twist small smelting nozzle Fig.
Care For cleaning, please 4o nat use any hard objects and agents. s frequently sufficient to use a cloth moistened with wishing-up hound sits {not oo wet). important for trouble-tee operation are clean thermometers, ignition plugs, and bores i the burner covers. Do not modify thermoplastic when cleaning. Under low dosing conditions, the burner covers clean themselves (during cooking).
Installation instructions Electrical connection (appliances with connected load below 3000 watts) Warning! All appliances with a 3 core lead must be earthed. Voltage and current Please ensure that the voltage and current indicated on the rating plate agrees with the voltage of your electricity supply. 220240 vomits ~ {i.e. 220/240 V. a. ¢} Electrical connection Please motel (For users in the U. K.).