User manual

12
Installation
l The following instructions about installation and maintenance must be carried out by
qualified personnel in compliance with the regulation in force.
l The side walls of the unit in which the hob is going to be installed must not exceed the
height of the working top.
l Avoid installing the appliance in the proximity of inflammable materials (e.g. curtains,
tea towels etc.).
l The appliance must be electrically disconnected before all interventions. If any electric
supply to the appliance is required to carry out the work, ensure all the necessary
precautions are followed.
THE MANUFACTURER WILL NOT ACCEPT LIABILITY, SHOULD ANY OF THE OTHER
SAFETY INSTRUCTIONS INCORPORATED IN THIS BOOK OR THE REGULATION IN
FORCE BE IGNORED.
Gas connection
Choose fixed connections or use a flexible pipe in stainless steel in compliance with the regulation
in force.
If using flexible metallic pipes, be careful they do not come in contact with mobile parts or they are
not squeezed. Use the same attention when the hob is combinated with an oven.
IMPORTANT - To ensure a correct operation, a saving
of energy and the long-life of the appliance, the voltage
pressure of the appliance must correspond to the
recommended values.
The adjustable connection is fixed to the comprehensive
ramp by means of a threaded nut G 1/2".
Interpose the sealing between the components as
shown in Fig. 1.
Screw the parts without forcing, adjust the connection
in the required direction and tighten everything.
IMPORTANT - When the final connection has been
made, it is essential that a thorough leak test is carried
out on the hob and installation. Use some soapy water,
never a flame.
A) Ramp with ending nut
B) Seal
C) Adjustable connection
FO 0264
Fig. 1