Specifications

D2.1.7 FB210

FB210 is called by FB200 at a selected reading order. Herewith, the data words of

the PCS data block addressed by the ADR_W variable are written into the send

buffer of the programmable controller. The number of consecutive data words is

defined by the DW_COUNT_W variable.

D2.1.8 FB211

FB211 is called by FB200 at a selected writing order. Herewith, the data in the

receive buffer are written into the PCS data block. The ADR_W variable indicates

the position in the data block. The number of consecutive data words is defined by

the DW_COUNT_W variable.

D2.1.9 FB212

FB212 is called by FB200 at a selected AND order. Herewith, the data in the receive

buffer and the corresponding data in the PCS data block are logically ANDed

and are written back into the PCS data block. The ADR_W variable indicates the

position in the data block. The number of consecutive data words is defined by the

DW_COUNT_W variable.

D2.1.10 FB213

FB213 is called by FB200 at a selected OR order. Herewith, the data in the receive

buffer and the corresponding data in the PCS data block are logically ORed

and are written back into the PCS data block. The ADR_W variable indicates the

position in the data block. The number of consecutive data words is defined by the

DW_COUNT_W variable.

D2.2 Loading of the handling software

Warning!

Check the functioning of the handling software to avoid PCS and/or

programmable controller malfunctions.

1. Connect the programmable controller and the PC via the programmable con-

troller programming cable.

2. Run the DOLOG software on the PC.

3. Load the AEG250PX program.

4. Transfer the program into the programmable controller.

Now, you can interface the PCS as described in section 2.4.

PLC handling software