User manual

English
31
SR4373SD-USB_IM_new2 17. 05 .16
15 / MODE button
Reverse (not shown)
AC IN ~ Mains connection
AUX IN input
PHONES headphone jack
Underside (not shown)
Battery compartment
Start-up of the Device / Introduction
• Select a suitable location for the device, such as a dry,
fl at, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is suffi ciently ventilated!
• Sensitive surfaces, such as the display, might be protected
with fi lms. Remove such fi lms.
Power Supply
1. Ensure that the voltage is the same as that indicated on
the model identifi cation plate.
2. Connect the power cable supplied (see battery compart-
ment if necessary) to a properly installed safety power
socket and the mains connector AC IN ~ on the back of
the machine.
Inserting the Batteries (not supplied)
1. Open the lid of the battery compartment on the bottom.
2. Insert 4 batteries of type UM 2 / R 14 1.5 V. Please ensure
that the polarity is correct (see the fl oor of the battery
compartment)!
3. Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are auto-
matically switched off.
CAUTION:
• Batteries can leak battery acid. If the device is out of use
for a long period of time, remove the batteries.
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer’s.
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fi re or the like. Danger of explosion!
Turning Device on / off
• Press the
 button to turn on the device.
• To turn off the device, press the  button for approx.
3 seconds. Then disconnect the mains plug.
NOTE:
After approx. 10 minutes without signal or with very poor
signal, the device will automatically switch to standby.
Volume
You can adjust the volume with the buttons
 /  .
Select the Operating Mode
Press the
/ MODE button repeatedly to select the desired
operating mode. The device switches from FM mode to AUX
mode, to USB mode, and to CARD mode.
NOTE:
• AUX mode can be selected only when an audio cable is
connected to the AUXIN jack.
• If no USB stick and no memory card has been inserted,
the display shows the message “
USB CARD“.
PHONES Headphone jack
For headphone operation, use headphones with a 3.5 mm
jack plug that you plug into the headphone jack of the
device. The loudspeakers will be shut off.
Set the Time
NOTE:
The setting is stored automatically when no button is
pressed for approx. 5 seconds.
1. Switch the device to standby.
2. Press the
button for approx. 3 seconds. “24H” fl ashes
in the display.
3. Select 24 hour or 12 hour display with the buttons / .
NOTE: In case of 12 hour display, the display shows:
AM = morning, PM = afternoon
4. Confi rm your selection with the button
. The hour digits
starts fl ashing.
5. Set the hour with the buttons / .
6. Confi rm your setting with the button . The minute
digits start fl ashing.
7. Set the minutes with the buttons / .
8. Finally press the button to store the time.
Listening to the Radio
1. Use the / MODE button to switch the device to FM
mode.
2. Completely extend the telescopic antenna. Change its
position to improve the reception.
3. You can search for stations in two ways:
Automatic Station Search
Important! Previously stored radio stations will be re-
placed by new stations.
Press the
button for app. 3 seconds. The stations are