User manual

English

DVD4556LCD_IM 16 .12.16

USB Port (Fig. 1/11)

Plug a USB storage device directly into the correct port of the device.

NOTE:

■ The USB port is not designed for charging external devices.

■ The USB port is only intended for playing media ﬁles from commercially

available USB sticks.

Card Slot (Fig. 1/1)

Insert an MMC / SD or MS card with the label facing back in the card slot of the

device.

For further use with a USB storage device or memory card, please refer to section

Page 45 “Work in Data Mode”.

Switching on the Device (Fig. 1/15; Fig. 2/2)

Turn the device on by sliding the “ON/OFF” main switch on the side of the

device to “ON”. The buttons / / / (Fig. 1/7) and / (Fig. 2/9) light

up red.

NOTE:

In Dual mode, the DVD MONITOR must be switched on so that the power

supply is fed to the second monitor.

Connect to Other Devices

■ Connect an AV cable to the AV IN socket (Fig. 2/3) and to the playback

device to view images of another playback device (such as digital camera).

NOTE:

Other devices can only be connected to the LCD Monitor (slave monitor).

Connect a coaxial cable (not included) to transmit the digital audit signal to your

playback device or your ampliﬁer.

1. Plug the Audio plug into the COAXIAL socket of the DVD monitor (Fig. 1/12).

2. Insert the audio plug into the corresponding socket of your playback device

or your ampliﬁer.

Connect an A/V cable to AV OUT (Fig. 1/13) and to the TV set to view images on

the TV set.

Switch the TV set to AV IN. Observe the TV’s user manual.

NOTE:

You need an audio cable with a 4-pin 3.5 mm jack plug to cinch socket, with a

pin length of 15 mm.

LCD Monitor - Change Display Settings

■ Press the MODE button (Fig. 2/8), to display the Setup menu.

■ Use the

and buttons (Fig. 2/9) to select the option. Use the and

buttons (Fig. 2/7) to change the setting.

Side Panel Inputs

Connect Other Playback Devices

Digital Audio Transmission

Connect TV Set