User manual

English
84
Taking Temperature in Ear Temperature Mode
1) When the system is in the state of time/environmental tem-
perature display, press the button of scan, and the last tempera-
ture measurement will be displayed; then after “Beep-Beep“,
the system enters into the mode of measurement.
2)Removetheprobecap,andthethermometerentersinto
theearmeasuringmode(RefertothePicture7.1).
3) Carefully pull back the ear to stretch the auditory canal.
When measuring ear temperature, insert the probe into
the ear rst (refer to the Picture 7.2), then press the but-
ton of scan. One second later you will hear “Beep“, and
you can remove the thermometer. The measurement is
completed.
4)Whenthemeasuredtemperatureexceeds38.0°Cthethermometerwill
send out “Beep-Beep-Beep“ a long one and two short ones, and the
displaywillshowtheiconoffever(RefertothePicture7.3).
Notes:
• Keeptheprobesurfaceclean,otherwisethemeasurementcan‘tbe
accurate.
• Cleantheprobewithcleanclothorpapermoistenedwithwateror
alcohol, and conduct measurement after the water on the surface of
the probe all evaporates.
(Picture 7.1)
(Picture 7.2)
(Picture 7.3)