User manual

The flashes when you connect the
appliance to the electrical supply, when
there was a power cut or when the timer
is not set.
Press the or to set the correct
time.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
4.3 Changing the time
You cannot change the time
of day if the Duration or
End function operates.
Press again and again until the
indicator for the Time of Day function
flashes.
To set a new time, refer to "Setting the
time".
4.4 Preheating
Preheat the empty appliance before first
use.
Preheat the two ovens. Heat
up one oven at a time.
1. Set the maximum temperature.
2. Let the appliance operate for 1 hour.
3. Set the function .
4. Let the appliance operate for 15
minutes.
Accessories can become hotter than
usual. The appliance can emit an odour
and smoke. This is normal. Make sure
that the airflow is sufficient.
5. HOB - DAILY USE
WARNING!
Refer to Safety chapters.
5.1 Ignition of the hob burners
Always light the burner
before you put on the
cookware.
WARNING!
Be very careful when you use
open fire in the kitchen
environment. The
manufacturer declines any
responsibility in case of the
flame misuse.
1. Turn the knob for the hob to the
position and push it down. When
you push the knob, the spark
generator activates automatically.
2. Keep the knob for the hob pushed
for equal or less than 10 seconds to
let the thermocouple warm up. If not,
the gas supply is interrupted.
3. Adjust the flame after it is regular.
WARNING!
Do not keep the knob
pushed for more than 15
seconds. If the burner does
not light after 15 seconds,
release the knob, turn it into
the off position and try to
light the burner again after
minimum 1 minute.
If after some tries the burner
does not light, check if the
crown and its cap are in the
correct position.
In the absence of electricity
you can ignite the burner
without an electrical device.
In this case approach the
burner with a flame, push
the relevant knob down and
turn it to maximum position.
Keep the knob pushed for
equal or less than 10
seconds to let the
thermocouple warm up.
www.aeg.com10