User manual

A
A
B
Minimum distances
Dimension mm
A 2
B 685
13.3 Levelling of the appliance
Use small feet on the bottom of
appliance to set the appliance top
surface level with other surfaces.
13.4 Anti-tilt protection
Adjust the appliance to the correct
height and put it in the correct area
before you attach the anti-tilt protection.
CAUTION!
Install the anti-tilt protection
to prevent the appliance
from falling under incorrect
loads. The anti-tilt
protection only works when
the appliance is put in a
correct area.
The anti-tilt protection has two parts (A +
B). You can find the anti-tilt protection (B)
on the right or left side of the rear wall of
the appliance.
B
1. Install the anti-tilt protection (A) on
the wall.
Make sure that the wall is made of a
solid material. If not, you need to
make the wall sufficiently strong to
hold the weight.
Make sure that the surface behind
the appliance is smooth.
2. Put the appliance in the middle of
the space between the cupboards.
If the space is larger than the width
of the appliance, you must adjust the
side measurement.
3. Install the anti-tilt protection (A)
approximately 77 mm below the top
surface of the appliance and 50 mm
from the left or right side of the
appliance into the circular hole on
the bracket. Screw it into the wall.
50 mm
77 mm
A
4. Check that the anti-tilt protection (A)
fits minimum 20 mm into the hole in
the rear wall of the appliance (B)
when you push the appliance.
13.5 Other technical data
WARNING!
These instructions are only
valid in the countries whose
symbols appear on this
booklet's cover.
www.aeg.com26