User manual

50 mm
77 mm
A
4. Check that the anti-tilt protection (A)
fits minimum 20 mm into the hole in
the rear wall of the appliance (B)
when you push the appliance.
13.5 Electrical installation
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
13.6 Covering terminal board
The recommended cross-section area
is six square millimetres (6 mm²).
When you refit the mains terminal
cover, make sure that the lower tabs
are located inside the bottom edge of
the aperture, before you fix the two
screws into the top edge of the mains
terminal cover.
Make sure that the cover is securely
fastened.
To open the cover of
terminal board obey the
procedure in opposite
sequence.
13.7 Terminal board
Do not remove blanking
plates.
Make sure that the links are fitted as
shown.
N N N
LL
14. ENERGY EFFICIENCY
14.1 Product information for hob according to EU 66/2014
Model identification 49002V-mn
Type of hob Hob inside Freestanding Cooker
Number of cooking zones 4
Heating technology Radiant Heater
Diameter of circular cooking
zones (Ø)
Left front
Left rear
Right front
Right rear
21.0 cm
14.5 cm
18.0 cm
18.0 cm
www.aeg.com34