User manual

13. INSTALLATION
WARNING!
Refer to Safety chapters.
13.1 Technical data
Dimensions
Height 894 - 912 mm
Width 600 mm
Depth 600 mm
13.2 Location of the appliance
You can install your freestanding
appliance with cabinets on one or two
sides and in the corner.
A
A
B
Minimum distances
Dimension mm
A 2
B 685
13.3 Levelling of the appliance
Use small feet on the bottom of
appliance to set the appliance top
surface level with other surfaces.
13.4 Electrical installation
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
13.5 Covering terminal board
• The recommended cross-section area
is six square millimetres (6 mm²).
• When you refit the mains terminal
cover, make sure that the lower tabs
are located inside the bottom edge of
the aperture, before you fix the two
screws into the top edge of the mains
terminal cover.
• Make sure that the cover is securely
fastened.
To open the cover of
terminal board obey the
procedure in opposite
sequence.
13.6 Terminal board
Do not remove blanking
plates.
Make sure that the links are fitted as
shown.
www.aeg.com
34