User manual

To deactivate the function: activate the
hob with . Do not set the heat setting.
Touch for 4 seconds. comes on.
Deactivate the hob with .
To override the function for only one
cooking time: activate the hob with .
comes on. Touch for 4 seconds.
Set the heat setting in 10 seconds. You
can operate the hob. When you
deactivate the hob with the function
operates again.
5.14 OffSound Control
(Deactivation and activation of
the sounds)
Deactivate the hob. Touch
for 3
seconds. The display comes on and goes
out. Touch
for 3 seconds. or
comes on. Touch of the timer to
choose one of the following:
- the sounds are off
- the sounds are on
To confirm your selection wait until the
hob deactivates automatically.
When the function is set to you can
hear the sounds only when:
you touch
Minute Minder comes down
Count Down Timer comes down
you put something on the control
panel.
5.15 Power management
function
All cooking zones are connected as
on the illustration.
The hob and both ovens are
connected to one phase.
The phase has a maximum electricity
load.
The function divides the power within
the appliance. The oven is more
important than the hob.
The function activates when the total
electricity load in the appliance is
exceeded.
The function decreases the power on
the cooking zones to prevent a circuit
overload.
The heat setting display of the
reduced zones changes between two
levels.
6. HOB - HINTS AND TIPS
WARNING!
Refer to Safety chapters.
6.1 Cookware
For induction cooking zones
a strong electro-magnetic
field creates the heat in the
cookware very quickly.
Use the induction cooking
zones with correct cookware.
Cookware material
correct: cast iron, steel, enamelled
steel, stainless steel, the bottom
made of multi-layer (with correct mark
from a manufacturer).
not correct: aluminium, copper,
brass, glass, ceramic, porcelain.
Cookware is correct for an induction
hob if:
some water boils very quickly on a
zone set to the highest heat setting.
a magnet pulls on to the bottom of
the cookware.
ENGLISH 13