User manual

CAUTION!
Only use the core
temperature sensor supplied
with the appliance, or
genuine replacement parts.
1. Put the point of the core temperature
sensor into the centre of the meat.
Make sure that the core temperature
sensor stays in the meat and in the
socket during the cooking.
2. Put the plug of the core temperature
sensor into the socket on the side of
the appliance.
3. Activate the appliance.
4. Press again and again until the
main oven appears.
5. Set the core temperature:
a. Press again and again until
the function core temperature
sensor flashes and the display
shows the core temperature.
The default core
temperature is 60 °C.
b. Press or in less than 5
seconds to set the core
temperature.
The core temperature is displayed from
30 °C.
6. Set the oven function and, if
necessary, the oven temperature /
.
While the appliance calculates the
approximate end time, the display
shows a square that flashes.
The appliance calculates the
approximate end time for the set core
temperature again and again. The
display constantly shows the new
approximate end time.
7. Press a button to stop the signal.
An acoustic signal sounds, when the
meat is at the set core temperature.
8. Remove the plug of the core
temperature sensor from the socket .
Remove the meat from the
appliance.
9. Deactivate the appliance.
WARNING!
Be careful when you remove
the tip and plug of the core
temperature sensor. The
core temperature sensor is
hot. There is a risk of burns.
8.14 Inserting the oven
accessories
Deep pan:
Push the deep pan between the guide
bars of the shelf support.
Wire shelf and the deep pan together:
Push the deep pan between the guide
bars of the shelf support and the wire
shelf on the guide bars above.
ENGLISH
19