User manual

English
43
7 Cleaning brush
8 Power adapter
9 Charging station/stand
Table: Cutting step versus cutting length
Cutting step Cutting length
1= approx. 5 mm
2= approx. 8 mm
3= approx. 11 mm
4= approx. 14 mm
5= approx. 17 mm
6= approx. 20 mm
7= approx. 23 mm
Charging the Unit
• Turntheunitoff.“OFF”canbeseenontheswitch.
• Connectthepoweradaptorconnectorwithoneofthefollowingjacks.
• Thesocketdirectlyatthebottomendoftheunit.
• Alternativelyplacetheunitinthechargingstation.Thesocketisattherear.
• Plugthepoweradaptorintoa230V/50Hzwalloutlet.
• Theindicatorlightremainsredduringthechargingprocess.
NOTE:
The charge indicator does not indicate the state of charge of the rechargeable battery.
• Chargetheunitbeforerstusefor10hours.
NOTE:
• Afterinitialuse,donotchargethebatteryforlongerthan8hoursatonetime.
• Ifthebatteryisempty,theappliancecanbeoperatedfromthemains.Todoso,con-
nect the adapter directly to the clipper.
CAUTION:
After 8 hours always disconnect from mains power supply.