User Manual

34
Safety Instructions for the Installer
• The mains connection must be with a cable with a plug or there must be a
disconnecting device with at least 3 mm contact opening in the existing
domestic electrical installation, which disconnects the dishwasher comple−
tely from the mains supply in accordance with NIN 2000.
• In respect of fire protection, this appliance corresponds to type Y (EN 60
335−2−6). Only this type of appliance may be installed with a high cupbo−
ard or wall on one side.
• It is not permitted to fit drawers below the cooking surface.
• Protection against electric shock must be provided by the installation.
• The kitchen unit in which the appliance is fitted must satisfy the require−
ments of DIN 68930 in respect of stability.
• Built−in ovens and cooking surfaces are fitted with special connector sy−
stems. They may only be combined with appliances with a matching system.
• All cut surfaces are to be sealed with a suitable sealant for protection
against moisture.
• On tiled work surfaces, the joints in the area where the hob sits on the sur−
face must be completely filled with grout.
• On natural, artificial stone, or ceramic tops, the snap action springs must be
bonded in place.
• Ensure that the seal is correctly seated in the frame and that it is seated
against the work surface without leaving any gaps. Additional silicon sea−
lant must not be applied, this will make removal more difficult in the event
of the need for service.