Service manual
5 599 519 523 EN
DGS-TDS
21.04.08
2.2 Individual cooking zones do not work (partially) or work incorrectly or
cannot be used
Alarm Symptom Cooking
Hob
Display
Possible Alarm
Cause
Alarm Remedying
Pan does not heat
up.
Normal
cooking
phase
Pan in the border
area of the pan
detection and only
works with low power
Use different pot or this pot on a smaller
hob. See Chapter 4 Pot Detection
Information
Flashing
"F“
Pan not detected. Check whether the pots or pans are
suitable for induction. See 4 Pot Detection
Information
Coil not correctly
connected.
Check whether the coil lines are connected
and the torque has been adhered to.
Distance between coil
and glass ceramic too
large.
Check whether the coil is applied to the
glass ceramic and whether the glass was
pushed was pushed down when screwing
in position.
Display "F" with 2
hobs with all pots
(also 1 hob with 3
hob models)
Flashing
"F“
1 phase missing ; only
possible with
induction SW.Ver.
0.50.
(1) Test the pin assignment and
230VAC between 4 N and the 2 phases on
supply line terminals 1 and 2.
Both of the "N“s should be connected to
terminals 4 + 5, if appr. jumper.
Should the above not succeed, replace the
affected power component..
No power on all hobs Normal
cooking
phase
Demo mode
activated.
See Chapter 5.2
Individual buttons
cannot be used or
cannot always be
used.
Touch Control defect. 1) See Chapter 5. Touch Control Autarkic
Cooking Hobs Information..
2) Should this not help, replace Touch
Control.
Cooking hob power
too low or not
provided for a longer
duration.
Normal
cooking
phase
Incorrectly installed,
exhaust not possible
to the front.
(4) Change installation situation.
Unsuitable pots
(bottom bent)
See Chapter 4 Pot Detection Information
Induction coil is not
applied to the glass
ceramic
Check whether the glass ceramic was
pushed down when being screwed in
position and the coil has been correctly
positioned.
Fan does not start. 1) When setting a cooking phase >0, the
fan runs at a slow speed. If not, check the
fan for foreign bodies, remove these where
appropriate.
2) If necessary, replace fan.
3) Should this not succeed, replace power
component.
"H" in display when
cooking hob and
oven cold and
switched off.
"H“ Temperature sensor
defect.
Replace corresponding coil with
temperature sensor. Also see Instructions
"E4“.