Service manual

20 599 519 523 EN
DGS-TDS
21.04.08
Assembly of band cable
(30) (31)
Open locking (black bar) Put band cable (silver contacts visible)
Close locking in arrow direction
(32)
Turn down the electronic with displays onto the glass side, press the carrier flatly to the glass lower side
and let it lock in. For assembly press the locking slightly to the bottom.
6.2 Demo mode / Self test
To enter the self-test/Demo mode, the following sequence of buttons must be pressed:
1. Hob is off. Press main switch continuously until display is going off.
2. Press the "+" and " -" buttons of the zones together (short beep) for about 3 seconds