Service manual

Service-Bulletin
DGS-TDS-N © Electrolux
14.02.07
599 528 416
Cooking appliances EN
Scorch locations with plug connections
Problem: Charred respectively burnt plugs/pin terminals with electronics and switches.
Reason: Due to faulty crimpings or expanded plugs arise scorch locations within the area of the line
connection. When you leave the former plug in case of a service, e.g. when substituting a
defective electronic, this fault will repeat again in most cases.
Problem removal: In case of scorch and fire locations respectively within the area of plug connections
you always have to replace the affected connectors.
That means, cut the plug at the corresponding braid (cable) and connect a new plug.
Leave the former plug at the pin terminal and return it, if possible unchanged and packed in
good condition, together with the defective spare part to the works in Rothenburg to the
following address
AEG Hausgeraete GmbH
Abt.: DGT-QZ zu Hd. H. Leis
Bodelschwingstr. 1
DE-91541 Rothenbiurg ob der Tauber
The required pliers and the plug-in sleeves can be obtained as spare parts.
SP No. Description
899 298 001 194/4 AMP pliers
407 139812/9 Plug-in sleeve 4.8x0.8 St. nickelized 0.5-1.5mm²
899 298 001 301/5 Plug-in sleeve 6.3x0.8 St. nickelized 0.3-0.8mm²
899 298 001 302/3 Plug-in sleeve 6.3x0.8 St. nickelized 1.2-2.5mm²