User manual

1
2
3
2. Pull the front end of the shelf support
away from the side wall.
3. Pull the supports out of the rear
catch.
Install the shelf supports in the opposite
sequence.
12.4 Pyrolysis
CAUTION!
Remove all accessories and
removable shelf supports.
The pyrolytic cleaning
procedure cannot start:
• if you did not fully close
the oven door. In some
models, the display
shows "C3" when this
error occurs.
CAUTION!
Do not use the hob at the
same time as the Pyrolysis
function. It can cause
damage to the appliance.
During the pyrolytic cleaning the door is
locked. The symbol and the bars of
the heat indicator come up, until the
door unlocks. The door unlocks when the
temperature inside the oven is under
safety conditions and the pyrolytic
cleaning finishes.
During the pyrolytic cleaning the lamp is
deactivated.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Activate the appliance.
4. Set the Pyrolysis function (refer to
"Oven functions").
5. Touch .
6. Touch or to set the duration
of the cleaning procedure:
Option Description
1 1:00 h for a
low degree of
dirt
2 1:30 h for a
usual degree
of dirt
3 2:30 h for a
high degree
of dirt
You can use the End function to
delay the start of the cleaning
procedure.
7. Touch
to activate the Pyrolysis
function.
12.5 Cleaning reminder
To remind you that the pyrolytic cleaning
is necessary, the cleaning reminder
symbol
flashes in the display after
each deactivation of the appliance for
the next 10 seconds.
The cleaning reminder
goes out:
• after the end of the
pyrolytic cleaning.
• when you deactivate it in
the basic settings. Refer
to "Using the settings
menu".
12.6 Removing the oven door
To make the cleaning easier, remove the
door.
www.aeg.com
40