Operating instructions

16
Building over a kitchen unit with door
Proper arrangements must be taken in
designing the furniture unit, in order to
avoid any contact with the bottom of the
hob which can be heated when it is
operated. The recommended solution is
shown in diagram 3.
The panel fitted under the hob ("a")
should be easily removable to allow easy
access if technical assistance is needed.
The space behind the kitchen unit ("b")
can be used for connections.
FO 1013
3
Fitting the hob to the worktop
Before fitting the hob into the cut out,
an adhesive seal must be fitted to the
underside outside edge of the hob. It is
essential that no gaps are left in this seal in
order to prevent spillage near the hob
seeping into the cabinet below.
1) Remove the pan supports, the
burners caps and crowns and turn the hob
upside down, taking care the ignition
candles are not damaged in this operation.
2) Place the relevant sealing all around
the glass top edge, taking care that the
sealings meet without overlapping (Fig. 8).
3) Place the hob in the cut out, taking
care of its centring.
4) Fix the hob with the relevant screws
(Fig. 9).
FO 2108
a) Sealing gasket
Dimensions are given in mm.
##
##
#
Instructions for the Installer
a