Equipment and description Figure 1 A Dual circuit hotplate 12 cm and 2t cm @ with corresponding switch B Roaster plate 14.5 with corresponding switch G Hotplate 18 cm @ with corresponding switch D Hotplate 14.
Using the hotplates The correct utensils Always use pans with a fiat base. Uneven pots and pans do not absorb the heat from the cooking Zane properly, thus prolonging cooking times and causing permanent discoloration of the hob. For the same reason you should not use pans which are too small, but ones which are the same size as the cooking zone. Always make sure the pan is placed on top ot the cooking zone marks. This is the correct pan.
Using the hotplates Important I the surface is cracked or fractured, the hob st nat be used. The hob should be switched off at the mains supply and AEG Service Department called immediately. W After switching on the hob you will hear & faint hum. Do not be concerned. This noise is simply & feature of the radiant heating system and does not effect the operation of the hob.
Operation of the hotplates Roaster plate Switch on the small diameter hotplate (14.5cm) as described under “Simmering and frying”. The roaster plate is activated by means ot touch control CO (figure 4/F). The symbol T glows with a red control it. To turn off touch figure 4/F) CD again. Dual circuit hotplate The snail diameter hotplate {12 cm) is switched on as described under “Simmering and frying”. The dual circuit is activated by means of touch control € {figure 4/E).
Care and cleaning of the ceramic hob Cleaning procedure 1. Clean the ceramic hob after every use with & cigar, damp cloth and a lithe washing up liquid. Then wipe the cooking area dry with a clean cloth. No detergent residues should remain on the surface. 2. For light fo normal collage, clean the entire hob with Stael-fix * or Idol Edeistahiglanz * Then rinse the entire cooking area thoroughly with clean wale and wipe dry with & clean cloth, No detergent residues should remain on the surface. 3.
Installation ‘instructions For the installer Safety instructions According to the technical connection contagions of the electricity board serving your area, the appliance may only be connected to the mains supply by an approved electrical installer. in the fixed connection, a device allowing the appliance to be isolated on all poles from the mains supply with a contact opening width of at least 3 mm must be provided. Suitable isolating devices are Cooker Contort Units.
For the kitchen furniture installer Safety instructions Please note that veneers and plastic coatings on the unit housings must be treated with heat resistant adhesive (100 °C). Unless the plastic coatings and adhesives are heal-resistant, ihe coating may deform or come lose. The use of solid wood wall up stands behind the hob is allowable so long as the minimum distances indicated in the hob diagrams are complied with.
For the kitchen furniture installer Rating plate Please state the product number Juno and the serial number (F. No.} of the hob; these will be found on the information sheet accompanying this hob, The data given should be gusted for the purpose of servicing and when ordering spare parts. Please enter this data on the back of these instructions.
Hier Topschild aufkleben! {nur flr Werk) AEG Hausgerste AG Pontiac 1036 D-8500 Bamberg 1 © Copyright by AEG H 260 215 700 09901/02